Aftermarket brake light switch

[retroriderpro1022]

I just swapped out my bar and noticed that my rear brake light has decided to stop working. Super frustrating, right? I'm starting to think it might be that pressure switch. Has anyone had any luck with an aftermarket M10x1.25 switch? I could really use some advice here

 

[BRING IT ON!]

I tried running aftermarket M10x1.25 switches before and they usually work fine, but the cheap ones don't last long. Of course, don't expect much in cheap ones it's a hit or miss definitely. If you go that route, spend a little extra for a decent brand so you're not replacing it again in a month.

 

[owlduke]

Its probably the brake light switch. Most bikes use a hydraulic switch that bolts onto the master cylinder and triggers the light when you press the brake. Aftermarket M10x1.25 switches like the Goodridge or Viferr options usually work fine, just make sure the thread and pitch match your bike. Check fitment before buying, and you should be back to normal in no time.